Temperature control:-

Here is the circuit of a simple and inexpensive temperature controller which can control temperature  from about 20°C to 200°C with an accuracy of 0.5°C

PARTS LIST

RESISTORS

R1 , R2 ,	8.2 K
R4	1K THERMISTOR
R5	470 Ohm
R6	22 K
R7	820 Ohm
R3	All 100 Ohm

DIODES

D1	Zener diode 5.1V 400mW
D2 , D5 , D6	1N4001
D3 , D4	15V 1W

OTHERS PARTS

IC1	op-amp 741
T1	BC147
X1	18V
C1 , C2	Capacitor 470μ 50 V
R1	RELAY 12V 250Ω
S1	1-POLE, 10 way switch

 

 

CIRCUIT DIAGRAM

CIRCUIT DESCRIPTION:-

The controller has been designed and fabricated using the  op-amp IC 741 and a 1k thermistor as the temperature sensor. It is based on the principle of Wheatstone bridge. The ratio arms R1 and R2 of the bridge are kept fixed (say unity). The voltage across the thermistor, i.e. across the arm R4, is compared with the voltage across the variable arm R3 which is kept fixed for a particular temperature (using the op-amp).

When the bridge is not balanced the output of 741 drives transistor BC147 to conducting state. Thus, the relay is energised and switches the heater on. As the temperature increases, the voltage across the thermistor decreases and when this voltage is equal to the voltage across R3 (i.e. the preset value) the output of 741 becomes zero. The transistor then stops conducting, the relay is de-energised, and the heater is switched off. Band switch S1 gives the different ranges of temperature  and potentiometer VR1 is used for fine adjustments.